Quartz tiles on tile backerboard, which adhesive is best?

[Mark tiler 88]

hi all I've got 36 m of 600x600 Quartz tiles wat adhesive best to use on backer board I was thinking single part flex as its a extension on to a salon 6 rooms in total so quite awkward cuts nothing square so I don't want to have to keep mixing up addy I

 

[Dan]

What tile backer board is it?

 

[Time's Ran Out]

Quartz or resin? Who is supplying the tiles, do you know where they come from?

 

[Rookery]

Usually a 2 part. I'd be using Keraquick & latex.

 

[Mark tiler 88]

6 MM hardie 36 MM ply underneath screwed down every 8 inch its Quartz not sure who's supplier is as client is gettin then I said I will get sddy

 

[Lee@emctiles]

Id recommend an S2, Tilemaster Ulitmate.

 

[Kyle Knowles]

I'd go Tilemaster ultimate my self I'm doin a 30 ish meter kitchen with the grey ones back end of next month and I'm using Ultimate my self it's lovely to use unlike 2 part which is the pits of the earth

 

[Mark tiler 88]

Cheers mate should I seal tiles after grouting

 

[Lithofin BOB]

I would Check with the supplier, these may require sealing face and edge prior to grouting.

 

[Tile Shop]

For quartz, we've always suggested BAL Stone and Tile PTB mixed with 3 litres of water and 1 litre of AD1 for the floors, and for walls, their Rapidset Flexible Fibre also substituting 1 litre of water for AD1.

These are the best combinations we could find to keep the water content as low as possible without ruining the consistency of the adhesive. And BAL guarantee it.

 

[Time's Ran Out]

Quartz or resin? Who is supplying the tiles, do you know where they come from?

I ask because some available is of poor quality!
S2 Tilemaster for me.

 

[Dumbo]

hi all I've got 36 m of 600x600 Quartz tiles wat adhesive best to use on backer board I was thinking single part flex as its a extension on to a salon 6 rooms in total so quite awkward cuts nothing square so I don't want to have to keep mixing up addy I

I have fixed quartzite resin type tiles in my Ensuite single part flexible over dural ci matting . No problems used a water based sealer prior to grouting with bal micro max grout . Been down a few years now also has water underfloor heating below it