Pictures and set out 2

K

kaharrison9

All up and working know.

Cheers Dan.

Thoughts on the set out for the glass room.

The tiles have been centred on a 20ft glass front entrance which then then runs through the hallway.

Any thoughts on wether to centre on the vertical post in the glass room or run the grout lines through from the hallway continuing into the glass room but that will off centre the room.

There is to be glass steps so there is a kind of break in the 2 rooms.

Cheers.

Kevin

DSCF0199.JPGDSCF0201.JPGDSCF0202.JPGDSCF0200.JPGDSCF0207.JPGDSCF0203.JPGDSCF0206.JPG
 
Also the wooden stairs are temporary there will be glass ones come down the left hand side of the wall each step inserted into the wall
 
If you continue the lines through how are the cuts to the right-hand wall? Does it leave a slither cut or a slither off? Is there skirting going on?
 
Nice looking job...........but I have to ask.....what is going on in the adhesive on picture 5?......
 
are there going to be steps down in to the glass room? if so you will have to follow the joints in my opinion, you will only have to work out the best layout front to back of that room then
 
you must follow the tiles you already have down if you want this to flow .as gary said then you have to work back to front i would probaly start full tile from the windows and work back if the windows are square as the step down will give you a 300 to 400mm look to were the next tile starts depending at what lenght you look at it from
 
The steps are not tiled and are glass so there is a type of break in the continunity of the grout lines. Either set out leaves a very good cut on the right side wall. Black ash skirting boards and a 150mm black ash border between the window and the tile. From the main door following through would look great though get to the top of the steps and the glass room looks to be crying out to be centred on the post. I suppose white grout will appear more subtle. I don't know what has happened to the addy looks like my 4 your old has ran threw it!
 
Yes the windows are square with the room and was planning to come a full time off them leaving about a 350mm cut on the back wall
 
what is the reason for using ditra..is this a new build so then allowing for lateral movement given its going to settle ?
 
love the sharp eyes on folk haha!

are you continuing tiling from existing tiles ? If not how come you did not take the set out into consideration for the glass room ?
 

Advertisement

Thread Information

Title
Pictures and set out 2
Prefix
N/A
Forum
Canada Tile Advice
Start date
Last reply date
Replies
11

Advertisement

Tilers Forums Official Sponsors

Thread statistics

Created
kaharrison9,
Last reply from
cam_low,
Replies
11
Views
1,857

Thread statistics

Created
kaharrison9,
Last reply from
cam_low,
Replies
11
Views
1,857
Back