Stainless steel splashback.....

[monty]

Hello peeps,

I've just finished tiling a brick bond slash back and everything looks good and I'm happy with the job BUT........ theres one thing doing my head in...There is a stainless steel plate above the cooker and where I have tiled up to this stainless steel there is obviously a cut edge ( It's running up at a angle to the extractor fan) So I have run a line of Silicon up both the joints and I'm not happy with the finish....
Any ideas what i can do to sort this out? BTW the tile edge is sticking out 6 mm

Thanks

 

[charlie1]

Can you post a pic mate?

 

[MICK the Tiler]

Is the tile thicker than the stainless steel Monty? square tile trim would have solved the problem m8.

 

[monty]

No charlie I didn't take a pic (should have though)

Yes mick the tile is thicker (I know i should have done that but thought Silicon would be ok learn from mistakes eh)... Think I'm going to cut some trim down with the wet saw and stick it with Silicon...what do you think? Or the other option is buy one of the Silicon kits from trade tiler to get a neater joint?

Thanks for the replies guys..

 

[MICK the Tiler]

No charlie I didn't take a pic (should have though)

Yes mick the tile is thicker (I know i should have done that but thought Silicon would be ok learn from mistakes eh)... Think I'm going to cut some trim down with the wet saw and stick it with Silicon...what do you think? Or the other option is buy one of the Silicon kits from trade tiler to get a neater joint?

Thanks for the replies guys..

Yeah I reckon cutting the trim down with the wet saw would be worth a try good idea let us know how you get on.

 

[monty]

Thanks Mick....I will let you know..

 

[pjtiler]

pack the splash back out with scrap tiles then slide your tiles behind
(there only stuck on with Silicon )

 

[Alberta Stone]

Just use a strip of schluter trim, titanium or pewter finish.
nice clean finish.
no Silicon.