How best to Tile a room? - TilersForums.com

[gamma38]

It isn't going to end well. Good advise ignored. There is no helping someone who thinks throwing down a few tiles is easy. UFH, different substrates, deflection issues, awkward cuts and all with 800 x 800 tiles.

What could possibly go wrong with this diy job....

 

[mp3wizard]

Well I didn't ask should I do it or not, I asked how best to do it.

 

[Dan]

I've bought all the materials and equipment so I will be doing it myself.

You missed a trick there, did you pay retail price?

 

[mp3wizard]

The tiles couldn't be got for cheaper, the tiler I was going to use checked, and I spent £150 on tools, so I can't see that massive savings would of been made, maybe £40 at most.

 

[Dan]

Fair enough. All the best then

 

[dave l and l]

good luck with doing this job then, dont use pva and dont dot and dab tiles .

 

[Qwerty]

On a serious note, take plenty of pics of before, during & after then start a new thread showing off your work.

I agree with most that you are better off getting a professional in, but at the same time I always love it when the underdog shines through and proves a point! At the end of the day this is your property and not like some we have had on here before wanting to take on complex jobs for paying customers without the knowledge.

 

[widler]

I'm with Plan, and if you are struggling come on for advice with photos and your problems, you never know some of 'us' may play nice

 

[mp3wizard]

thanks chaps, the first challenging part for me will be putting on the SLC I guess.

 

[Time's Ran Out]

I'm with Plan, and if you are struggling come on for advice with photos and your problems, you never know some of 'us' may play nice

That's mint!
Must be the Xmas spirit.

 

[WetSaw]

thanks chaps, the first challenging part for me will be putting on the SLC I guess.

..after you've confirmed there's no deflection in the floor of course.

 

[Rich Midge]

Just caught up with this. Fascinated to see how this goes. My advice @mp3wizard is don't be a stranger, ask, ask and ask again, many on here happy to help out. Best of luck.

 

[belg]

Back butter also. And leave space from the walls.

 

[mp3wizard]

Hi All,

Installing Insulation boards

I have got the 6mm Deltaboards, so firstly I was going to sweep the floor clean, then clean the floor with a sponge, wait until it's dry then paint the entire area with heatflex, once dry I was then going to lay the boards in a brick fashion, I was going to use 15 25mm screws on 35mm washers per board at 300mm differences to fix the boards down, once fixed I was then going to use some special thermal tape to tape the joints, and put a light skim of tile adhesive over the joints as per 3-falls picture on page 2.

Are there any problems with my plan so far?

I understand that I need to leave a 5mm gap all around the edges for expansion/movement is that correct? and because I will be looking to put the SLC ontop, would it be wise to purchase and install the spongy foam spacers all around the room for this purpose? because I'm worried that when I pour the SLC out, especially around the bifold doors that it will just go into the tracks if I don't protect it...

 

[Flintstone]

Your half way right, your best sticking the boards with tile adhesive as well as screwing. Use a 6 or 8mm notch trowel, no dot and dab.