which diamond blade?

[DHTiling]

That i don't know.. it is grinder bore.. and 100mm.. but it cuts super super fast it is unbelievable..

 

[DHTiling]

Oh! and Trade tiler has my feedback and is ordering a load in... so keep an eye out for them ..

 

[ukProTile]

I just got the nd300 and got rubi's porcelain blade! It eats through high grade porcs like its soft ceramic! so quick! 2 hp motor.....BEAST

 

[White Room]

I have the nd200 with marcrist blade

 

[Andy Allen]

I have the nd200 with marcrist blade

is it as good as they say it is .......ie. eats porcelain for breakfast.

 

[White Room]

If I'm cutting a right angle from a tile I'll cut into the corner, then snap..

Did have some chipping of the porcelain at first, don't notice it now but it does cut really well,

 

[Alberta Stone]

They cut really well but mine drifts on the cut on my Rubi rail cutter!

Not necessarily the bearing runners.
If it is a 10 inch blade then it is due to the blade edge getting worn round.
I have this problem crop up regular.
When a blade is new it cuts straight as can be with no drift, but after it wears round it will track over 1/16 to 1/8.
I have taken to having a little plastic wisk brush I have cut into short lengths which I clear chips off of the table with and I use it to keep the blade straight as I run it through a tile and that works well.
I just push the plastic against the blade to keep it running true.
Don't like to but also don't like replacing blades too often.

 

[doug boardley]

I'm getting the montolit dna blade next time.

 

[Alberta Stone]

That dna blade sounds like a good one from what I have read on it.
Alpha makes some good blades as well.

 

[Homza]

Sorry for digging up an old thread. I have a Raimondi T3 Razor. Best blade I have ever used for porcelain. It is a j slot blade, very thin but the core is thicker. Prevents wandering. Works best if you dress it regularly with their blue dressing stone.
But maybe you guys are a few years ahead of us in blade technology.