Removing edge tiles with UFH

[Mr Tiler]

ooooooo sorry lol

 

[Timo]

Apparently a sparky is going there soon to fit some lights so the owner will get them to connect the existing UFH up and use their multimeter to (hopefully) detect where the UFH wires run. He has some proximity sensor to detect live wires apparently. No idea? Fingers crossed it can detect the 240V AC through the adhesive. And then he'll just mark along the adhesive where the wires are and I'd chisel around them.

The sparkies non-contact livewire sensor didnt work because (he said) the cables are shielded. So the homeowner bought a 'stud finder' and has reported some limited success detecting the cables through the adhesive and confirmed that with a 'back of the hand' warmth test now that the UFH is working again (thanks to the sparky).

So the homeowner is going to have a go at carefully chiselling out the adhesive where he was pretty sure there was no UFH (about 4 of the 6 tiles) because grinding the back of the tiles risks weakening them too much so they'd crack.

Any other tips / advice?

 

[J Sid]

If back of tile are ground and then layed to a solid bed they will be fine.

 

[Sean Kelly]

Timo, if ever you are laying UFH then I suggest you take a few photos of the wires before you pour self levelling compound over them. Just something I do.