A
Alan P
Hi,
Following a small water leak that led to the bathroom floor needing to be replaced I laid a new marine ply floor, gave it two coats of Bal prime apd, laid new electric underfloor heating followed by Bal fibrebase self smoothing compound, I then used Bal single part fastflex to lay the new tiles. That was 24 hrs ago.
I've just checked them and the adhesive doesnt seem to have hardened as much as I thought it might, it's still possible to push a knife into the adhesive, it's about the same density as hard rubber.
Can anyone tell me if this is correct?
Following a small water leak that led to the bathroom floor needing to be replaced I laid a new marine ply floor, gave it two coats of Bal prime apd, laid new electric underfloor heating followed by Bal fibrebase self smoothing compound, I then used Bal single part fastflex to lay the new tiles. That was 24 hrs ago.
I've just checked them and the adhesive doesnt seem to have hardened as much as I thought it might, it's still possible to push a knife into the adhesive, it's about the same density as hard rubber.
Can anyone tell me if this is correct?