Please checkout the following advertisement.
Hi,
Following a small water leak that led to the bathroom floor needing to be replaced I laid a new marine ply floor, gave it two coats of Bal prime apd, laid new electric underfloor heating followed by Bal fibrebase self smoothing compound, I then used Bal single part fastflex to lay the new tiles. That was 24 hrs ago.
I've just checked them and the https://www.tilersforums.com/forums/tile-adhesive/ doesnt seem to have hardened as much as I thought it might, it's still possible to push a knife into the https://www.tilersforums.com/forums/tile-adhesive/, it's about the same density as hard rubber.
Can anyone tell me if this is correct?
Following a small water leak that led to the bathroom floor needing to be replaced I laid a new marine ply floor, gave it two coats of Bal prime apd, laid new electric underfloor heating followed by Bal fibrebase self smoothing compound, I then used Bal single part fastflex to lay the new tiles. That was 24 hrs ago.
I've just checked them and the https://www.tilersforums.com/forums/tile-adhesive/ doesnt seem to have hardened as much as I thought it might, it's still possible to push a knife into the https://www.tilersforums.com/forums/tile-adhesive/, it's about the same density as hard rubber.
Can anyone tell me if this is correct?