Sigma Setup - TilersForums.com

[David Rowell]

Hi all,

So Ive getting myself a sigma cutter which cuts upto 725mm. Im having massive trouble with it and im not getting on with it at all like.

My question is how do you go about setting the thing up ie to get consistant cuts? Im at the point where when im going to snap the tile ive got no trust in it.

Any help fellas that would be much appreciated

Dave

 

[White Room]

Your measuring bar should have another sliding bar that can be screwed tight to do consistent cuts.

 

[Italy]

did you read the instruction booklet attached?

 

[Italy]

http://www.sigmaitalia.com/wp-content/uploads/istruzioni-2015a-A5-40-88.pdf

 

[David Rowell]

Your measuring bar should have another sliding bar that can be screwed tight to do consistent cuts.

Ive got that whitemeam, but i mean in the quality of the cuts and also they snap alot? Doing my head in lol

 

[David Rowell]

did you read the instruction booklet attached?

I would of loved too however the mrs threw it in the bin when a was at work

 

[David Rowell]

http://www.sigmaitalia.com/wp-content/uploads/istruzioni-2015a-A5-40-88.pdf

Your a star mate thanks very much Top man

 

[White Room]

Ive got that whitemeam, but i mean in the quality of the cuts and also they snap alot? Doing my head in lol

What tiles are you cutting...

 

[David Rowell]

What tiles are you cutting...

They are like a rough ish face and are 8mm. Is it normal to have to run the scoring wheel over a few times?

 

[David Rowell]

What tiles are you cutting...

If you were to change from cutting say 8mm to 15mm mate how would you set the bar up? ive just watched nearly 20videoa on youtube and none of them explain this