Cutting in 140mm shower rough in box - any advice? - TilersForums.com

[Jonathanb]

I done the same cut out for the Grohe box, used a angle grinder. It wasn’t to bad to do. It was my first attempt as I’m not a tiler

John..

 

[Jonathanb]

 

[Qwerty]

Dont forget to clip those speedfit pipes down so they dont bang around under sudden pressure change

 

[Jonathanb]

Dont forget to clip those speedfit pipes down so they dont bang around under sudden pressure change

They were clipped down before it was boarded

John..

 

[Old Mod]

They were clipped down before it was boarded

John..

How have things turned out John, all good?

 

[Jonathanb]

Yes all finished now, just the floor to do when I have the time. I’m back at work now so it’s a bit more difficult to get the time to finish things
It would of been a a lot harder to do without the help from this forum

John

 

[Old Mod]

It would of been a a lot harder to do without the help from this forum

John

You’ve done a cracking job John!
Fair play to you.
Looks really good.
I’m glad we were able to help.
Thank you for posting the almost end result

Don’t forget to keep coming back, we need to see the floor.

 

[Dumbo]

I don't understand this thread . It went form how do I cut this hole to finished bathroom ( less the floor ) in 8 hours .

 

[Old Mod]

I don't understand this thread . It went form how do I cut this hole to finished bathroom ( less the floor ) in 8 hours .

Because the finished bathroom doesn’t belong to the OP, this bathroom it’s from another thread.

My 1st Job - Concrete panels on bathroom walls? - https://www.tilersforums.com/threads/concrete-panels-on-bathroom-walls.86120/

 

[Old Mod]

This is how accurate a template can be.





Just for you @jcrtiling