P
project damager
Hi Team
I have attached a PDF of my setting out plans for my en-suite project and would be really grateful for the benefit of any advice from you all.
The room is 1.870 X 1.610. The tiles are 316mm X 450mm.
I am going to build a section in the rear right hand corner to accommodate a large vanity unit (scavenged from a previous project) and also the cistern for the WC.
The light shading is either where the Shower goes (an all in one steam shower unit), the WC or the free standing table for the sink.
I am planning to use a tile skirting detail which is approx 70mm high.
I have shown a 60mm void around the top of the tiles where I was going to remove the cornice but have since decided against it and will leave it.
By tomorrow evening I should have stripped out what I can, without the help of a plumber, and will post some photographs.
I would welcome any comments and advice
Thanks a lot!
Brian - The Project Damager
I have attached a PDF of my setting out plans for my en-suite project and would be really grateful for the benefit of any advice from you all.
The room is 1.870 X 1.610. The tiles are 316mm X 450mm.
I am going to build a section in the rear right hand corner to accommodate a large vanity unit (scavenged from a previous project) and also the cistern for the WC.
The light shading is either where the Shower goes (an all in one steam shower unit), the WC or the free standing table for the sink.
I am planning to use a tile skirting detail which is approx 70mm high.
I have shown a 60mm void around the top of the tiles where I was going to remove the cornice but have since decided against it and will leave it.
By tomorrow evening I should have stripped out what I can, without the help of a plumber, and will post some photographs.
I would welcome any comments and advice
Thanks a lot!
Brian - The Project Damager