Depth Of Slc Over Heat Mat System - TilersForums.com

[MTiler]

Always put down between 6-8 mm.
Webber floor flex states 10mm min over timber.
For mosaic i always do two layers as the second only a couple of mm and rolled out with the pin roller

I'm using Weber Floor Flex. How long do you wait before you put down second layer?

 

[MTiler]

My next question is how the hell am I going to lift a tub full of 25kg of slc and about 4-5 litres of water ? Lol

 

[Dave]

I'm using Weber Floor Flex. How long do you wait before you put down second layer?

When it's OK to walk on Sharon , depending on the version , one sets in 90 mins and the other 2-4 hrs. Don't forget floor flex is 10mm on timber.

 

[Dave]

My next question is how the hell am I going to lift a tub full of 25kg of slc and about 4-5 litres of water ? Lol

Mix in 2 smaller batches or in one tub and split into another for carrying upstairs

 

[MTiler]

When it's OK to walk on Sharon , depending on the version , one sets in 90 mins and the other 2-4 hrs. Don't forget floor flex is 10mm on timber.

That has been mentioned ta.

 

[MTiler]

Mix in 2 smaller batches or in one tub and split into another for carrying upstairs

Obviously lol

 

[Dave]

Obviously lol

Well you might not have thought that

 

[jobdone]

I always let it dry over night and prime between coats.
Put a board over the wire and knock up on that in the room. Dont forget clean water and a sponge for any splashing

 

[MTiler]

It's so annoying there's a nice flat floor lovely for mosaics but the customer is having UFH. Poo .

 

[Dave]

Oh the joys of being a tiler