d2400 cutting Un square - TilersForums.com

[tile89]

since
Buying my d2400 second hand it have never cut square , probably 2mm out on a 300mm length

What is the best way to adjust these ?
Just asking if anyone has had any experience
Thanks

 

[Bill]

hammer.

 

[J Sid]

Manual Library - http://usermanualslibrary.xyz/DEWALT-D24000-SERVICE-REPAIR-MANUAL.html

 

[Chris Gibbs]

This happened to mine also, but to be honest I was just pushing the table too fast into the cut. Hope it's as simple as that.

 

[Kyle Knowles]

Adjustments - Dewalt D24000 Instruction Manual [Page 11] - http://www.manualslib.com/manual/39497/Dewalt-D24000.html?page=11

 

[David - Tradetiler]

I wouldn't adjust anything before you have ruled out any blade issues. We nearly always find squareness issues on electric machines are related to blade sharpness. If you do decide to adjust the machine, find a way to mark the original position in case you need to go back.

 

[Kyle Knowles]

I've got the original dewalt blade in mine and its a very good blade I've cut everything from marble granite and porcelain and it cuts just fine