Hi
I’m just about to renovate small bathroom and replace bath with shower. We have very hard water so trying to use simple shower screen rather than sliding door which get all scaled up very quickly. So I guess it’s almost a wet room🙂 with open shower enclosure but a low 40mm tray. I intend to use marmox boards ( or similar) on wall and ply the t&g chipboard floor which is uneven and much chopped up ( by me over years).
I was going to join marmox wall to ply floor joint in the alcove where tray will be, with marmox self adhesive tape.
After the lengthy intro (sorry) , my question is if I install tray into alcove I need to silicon it to the wall, but will Silicon stick to the self adhesive tape I just used to seal wall/ floor joint? Id appreciate any advice
I’m just about to renovate small bathroom and replace bath with shower. We have very hard water so trying to use simple shower screen rather than sliding door which get all scaled up very quickly. So I guess it’s almost a wet room🙂 with open shower enclosure but a low 40mm tray. I intend to use marmox boards ( or similar) on wall and ply the t&g chipboard floor which is uneven and much chopped up ( by me over years).
I was going to join marmox wall to ply floor joint in the alcove where tray will be, with marmox self adhesive tape.
After the lengthy intro (sorry) , my question is if I install tray into alcove I need to silicon it to the wall, but will Silicon stick to the self adhesive tape I just used to seal wall/ floor joint? Id appreciate any advice
