Cutting large travetine

[penno]

Good morning all
Have been to look at a floor that a customer wants doing in 600mm travetine.
I haven't cut any travetine this size before and am gradually building up my kit.
Will my angle grinder and wet cutter be adequate to acheive a quality job or will i certainly need a bridge wheel cutter?
Cheers for your thoughts
Kev

If you have a decent blade on a grinder no reason atall you cannot achieve a quality job. Good grinder and blade will give you nice clean cuts if you are adept at using a grinder.

 

[Spud]

just a lot of dust with a grinder i would prefer a wet cutter as long its a good one

 

[Terry Cottar]

u can rent em cant u

tel

 

[doug boardley]

you can hire/rent wet cutters Tel

 

[Terry Cottar]

id probably rent one then in this situation and cost the rent in on the job

tel

 

[Perry]

use water with your angle grinder stops the dust but be careful and the dewalt looks limited

 

[kaharrison9]

Hi pjc
Thanks for your reply,in your eyes what makes the Dewalt limited?
Lots of folk saying it looks well but very interested in any negatives or comparisons.
Cheers
Kev