A rip out and redo bathroom to be tiled. - TilersForums.com

[Kieks]

Here is a job I’m on at the moment. A bathroom walls and floor, trying my woodwork skills out too

Started a couple of months ago. Joists were rotten, leaky wedi tray. Had to drop the ceiling down stairs, cut the joist back. Re joist.

Bit of a ball ache

I’ll try and keep it with daily (ish) updates.

 

[Qwerty]

Nice one. Great prep

 

[Kieks]

Nice one. Great prep

I’ve got to board out the final wall tomorrow, build a base for a shower to sit on, as no matter which way around we lay the tray the trap is bang center of a joist

I’ll then set it out an work out the height for a niche in the stud wall, board it and tank all wet areas.

 

[Kieks]

I’ve boarded the back wall, ready to be plugged and screwed. Built a little base for the shower to sit on.

A few holes for low level leds.

 

[Kieks]

My niche finished horribly. I didn’t have the tiles when I stud the wall. I’ve set out the room for up and down cuts.

A tile will run through that box, although I couldn’t have a full tile as the pipe work was in the way.

A right pain in the arse to sort it out

 

[Kieks]

After a slow start to the day, I managed to get some tiles on the wall. Although I didn’t have the best of days.

Firstly my niche box was not right, I must of measured it wrong cutting it out. It’s to small height wise. I’ll be able to sort it, but annoying!

Secondly I picked up a tile to use as a spacer above the door, tiled away only to realise once I got to the top, the tile I had picked up was not full length!

That really pissed me off! Now I have to put a close in tile unintentionally ha ha. It’s only 18 mm smaller so not so bad. But still!

I’ll upload a pic of the tile I used, along side a full tile.

 

[Kieks]

This seems to be taking me an age, but am getting there! Had to finish early today, shame as there’s only 10 or so tiles left to finish the walls.