Sigma Manual Tile Cutters - TilersForums.com

[Waluigi]

A few people have just recently entered the world of Sigma for their tile cutting use, myself included.

I thought it would be a good idea to start this thread for any tips on how to use these cutters.

For now, here’s a link to the Sigma Beochure which @callatiler kindly posted earlier:-

http://www.sigmauk.co.uk/wp-content/uploads/2016/01/2016Brochure.pdf

 

[Bill]

Don't forget to disengage the measuring bar when moving through doorways.......

 

[Waluigi]

I do have a very basic tip that everyone will already know.....

The measuring bar can be stored on the main tile body. It slots in and screws on.

 

[Fitwidge]

Don’t put to much pressure when scoring or snapping

When snapping try tapping, if that makes sense

 

[Blunt Tool]

Don’t oil the rail, just clean with 00 wire wool

 

[Blunt Tool]

Haha informative you see I do listen to you!

 

[Waluigi]

Does anyone use the Klick Klock handle?

 

[Old Mod]

I’m just an habitual victim of plagiarism

 

[Old Mod]

Does anyone use the Klick Klock handle?

Yes

 

[One Day]

Does anyone use the Klick Klock handle?

No

 

[Blunt Tool]

Ray came up to Aberdeen to see me, he said my Sigma was the smoothest he had ever pushed and gave me the trophy some guy down in London had.

 

[Old Mod]

Haha informative you see I do listen to you!

In actual fact, Lee MAC was the person who first posted that to my knowledge, well it could have just as easily been Antonio who was first, they’re the two sigma aficionados.
I just stole it from one of them.

 

[One Day]

A few I've learnt:

Always check the hole which the measure bar sits in for debris.
If you tighten the bar with tile fragments in the hole, it can sit wonky and mess up your cuts.

Set the correct height for each tile thickness by setting the breaker foot flat on the tile face - at the top and bottom of the tile.

Don't score more than once - I've never had to.

Don't score too hard.

You get a better break if after scoring, you nudge the tile a couple of mm away from the measure bar and set the breaker foot 10mm from the tile edge.

If you leave your cutter on the floor with muppets around, they will kick the measure bar and you won't realise until you've cut all your spare tiles with a raked cut!

 

[Waluigi]

What are the advantages of the klick klock. Can you see the scoring wheel easier? It’s not particularly easy to see on the Max Handle

 

[One Day]

What are the advantages of the klick klick. Can you see the shoring wheel easier? It’s not particularly easy to see on the Max Handle

No, not really. You don't need to see the scoring wheel - trust the measure bar!