URGENT! need advice TODAY, horizontal staring point (see drawing)

[jimbob]

Around edge of bath on door wall?
Do you mean running down the side of the bath?
Where the cross is?
View attachment 92839

Just move the joint up to the bath, from your drawing it doesn't seem to cause an issue.

The slither above the door is more difficult and tbh where it is, and how the rest of the room works, I wouldn't worry about it.
It runs in to the wall and is behind you when you enter.
There will ALWAYS be a compromise to make, we just do what we can to lessen the impact.

You can always fit a piece of 30mm timber on top of the architrave, fill it well and paint, probably be unnoticeable.
The architrave will just be taller.
It will depend on the profile of course.
View attachment 92840

Thanks again, yes where the cross is. I think I'm just being a little obsessive at this point.

 

[Old Mod]

Thanks again, yes where the cross is. I think I'm just being a little obsessive at this point.

Haha yeah I get that.
Just move your tile line over to the bath panel.

 

[NZ_Tiler]

What drawing programme are you using?

 

[jimbob]

What drawing programme are you using?

Just using sketchup for those quick drawings

 

[jimbob]

Update, this is what I went for

View media item 15361View media item 15360View media item 15359View media item 15358View media item 15357
What do you think?

 

[Andrew]

Full tile off bath

The tile above the window sticks out by 5mm either side as the window is 590mm and the tiles are 600mm. Also 74mm tile all around where wall meets ceiling. What do you think.

Drop everything by 1/3 tile even up floor and ceiling line cuts. Reduces over bath to 2/3 tile and balances cuts too and bottom of window.
Presuming this works for the rest of the room bingo!