Marcrist drill set??

[gamma38]

Hi does anyone know where the best and cheapest place to get a marcrist drill set??

 

[DHTiling]

Tradetiler.....


Have you looked at the 365 porcadrills.?

 

[gamma38]

Yes, I have a set now. Great drills. I just need to pick up the pace a little. Hard as porcelain, hundreds of holes to drill equals lots of time. I keep reading how quick the marcrist are so I thought it was time to upgrade.

 

[DHTiling]

No probs... try here then>>>>>>Tradetiler Tile Marcrist PG850 Porcelain tile drilling system

 

[gamma38]

Cheers i'll have a look. Are they as good as all the reviews say, as in quick, long lasting etc?

 

[DHTiling]

I have not personally used them but a few members have, await replies if you want feedback 🙂

 

[Gazzer]

I have a set of Marcrist and they are good but rarely use them as my 365 drills cope with everything so far.

 

[gamma38]

Cheers, Thanks for the quick reply, just had a look on there site and they seem reasonably priced.

 

[hillhead]

I was using a sigma 60mm core drill bit today and it was unreal on 30mm marble!
I was using it alone to cut out shower valves from slabs, very quick and sharp.
The sigma look a bit like the marcrist.

 

[White Room]

Was that with any water on the cutter...

 

[kilty55]

montolit cutters on an angle grinder have been the best by far that i have used so far

i have used marcrist,365 drills and rotozip cutters all are good as well

 

[hillhead]

We were using the sigma with no water, eating through 30mm marble with ease and no heating up. It was good and thick too!
We had 4 grinder/ polishers in action and dust everywhere, lol.