W
White Room
What backer boards, hardie don't do 10mm....
Tilers Forums Official Sponsors
B
Budha7
floor was down nearly 3 weeks before it was turned on.
I have checked the customers stat (intelligent), as far as i can tell it hasnt been above 27c.
I have checked the customers stat (intelligent), as far as i can tell it hasnt been above 27c.
T
TJ Smiler
It could just be me not seeing your photo clearly but it looks like there is not a shread of adhesive underneath your ditra.
The SLC could have cracked if it was to dry. Others may not agree with me but i never put anything on chipboard, even the moisture board. How wide apart are the joists and were you able to screw down all the corners of all boards? or was it just screwed down every 300mm along the joists?
The SLC could have cracked if it was to dry. Others may not agree with me but i never put anything on chipboard, even the moisture board. How wide apart are the joists and were you able to screw down all the corners of all boards? or was it just screwed down every 300mm along the joists?
it is either thermal or early drying shrinkage which you would have seen before you tiled. The dry lake bed though is absolute classic symptom of over heating too early in the process. Someone isn't saying something IMO.
My thoughts exactly
B
Budha7
The adhesive for holding the ditra is Ardex AF200 - ditras specified glue.
The SLC was made using the manufacturers spec as to the amount of water.
400mm joists. all corners screwed and full length down sides and centers.
its all very strange.
thankyou for the replies!!
The SLC was made using the manufacturers spec as to the amount of water.
400mm joists. all corners screwed and full length down sides and centers.
its all very strange.
thankyou for the replies!!
S
Spud
get the norcross technical involved they will be able to tell you what went on i would have thought
