Electric wet tile cutter running off

[barnfields]

I have a hired wet tile cutter and it is running off the line when I try a cut. Runs off by about 6mm over a 300mm til width. Tried altering rest and square but still running off. Doesn't matter if I cut v. slow it still runs off. Any ideas

 

[Rookery]

What type of saw? Bridge/tabletop etc

 

[barnfields]

Its a SIMGA 9M1

 

[barnfields]

Sorry, its a table top type.

 

[Gazzer]

Just mark the tile and guide the wheel through.

 

[barnfields]

Thanks I'll try that. It has a guide and table that slides so it should work but clearly doesn't.

 

[Sean SML Tiling]

I wouldn't pay for it or ask for a refund if its that bad. Tell them u couldn't use it and gdt your money back. What tiles you fitting

 

[Gazzer]

Thanks I'll try that. It has a guide and table that slides so it should work but clearly doesn't.

Without seeing it , it would be hard to say what the issue is.
Have you placed a full tile against the guide stops, then push up to the front of the wheel so the tile just touches the side of the wheel. Then slide it through to the end to see if the wheel is away from the tile at the end of the push ?

 

[barnfields]

I wouldn't pay for it or ask for a refund if its that bad. Tell them u couldn't use it and gdt your money back. What tiles you fitting

As far as I can tell the table is parallel with the wheel but it wants to cut in a curve. The tiles are a shade under 40cm square.

I had this before and took the machine back & swapped for another that worked fine. This is the same machine that worked OK last time. Does it wander off if the blade is worn?

 

[Sean SML Tiling]

Sometimes they do run off but not 6mm thats alot over a small area