Y
yetirider
Hi All
Tiller has just finished fitting 10mm honed limestone onto marmox boards.
A 4hr dry white addy was used but 24hrs latter we can see damp looking patches.
The addy is topps trade single part mix, it does say for stone on bag.
below is a link to the stone used
Classic Flax Mix Honed Limestone Stone
I've seen a few posts on here that suggest this is a start again job.
My question is, are these marks likely to dry out over a period of time, or can
we use a product to remove it?
Stone has not you been sealed, tilers has not had this issue with stone before,
ans we are a bit unsure how to proceed other than to leave it for a period and
see what happens.
I just thought i'd ask the question to get some advise.
Cheers Phil
Tiller has just finished fitting 10mm honed limestone onto marmox boards.
A 4hr dry white addy was used but 24hrs latter we can see damp looking patches.
The addy is topps trade single part mix, it does say for stone on bag.
below is a link to the stone used
Classic Flax Mix Honed Limestone Stone
I've seen a few posts on here that suggest this is a start again job.
My question is, are these marks likely to dry out over a period of time, or can
we use a product to remove it?
Stone has not you been sealed, tilers has not had this issue with stone before,
ans we are a bit unsure how to proceed other than to leave it for a period and
see what happens.
I just thought i'd ask the question to get some advise.
Cheers Phil