Discuss Montolit MasterPiuma P3 Series Comments Please in the Australia area at TilersForums. The USA and UK Tiling Forum (Also now Aus, Canada, ROI, and more)
Hi everyone, thinking of getting myself a Montolit 75P3 and just wondered what peoples experiences with this cutter series have been. Been working with some troublesome tiles that the TS-60 just can't handle and a friend has recommended the montolit to me in the past. Any Input on this would be more than helpful, Thanks.
Good cutters i reckon, I have two of them. I only use these and my family of sigma's nowadays. Sigma being by far the best but the monty's are a good cutter.
Do you think that i would be better off getting a sigma? If so could you explain why as I have no experience of using a sigma, only rubi, what makes it better than the Montolit? Also which model sigma is best?
I had montolit but switched to sigma...
good cutters tho..
I had montolit but switched to sigma...
good cutters tho..
Same here. Had the 63cm cutter and yes it was far better than a rubi but not in the same league as a sigma. The monty I found to be a little brutal on times and can easily smash tiles to bits.
Sounds like I should go with the sigma. Any opinions on the best model?
Dont listen to the conververts.montys are great better than sigmas. I started my career with a sigma and then discovered montys.Bring it on lads
Save your money & purchase a Sigma.
If your coming from a Rubi I would go for a max series, push cut.
Once you get the hang of the cutting action & lining up of the tile you will never look back.
Reply to Montolit MasterPiuma P3 Series Comments Please in the Australia area at TilersForums.com
Or checkout our tile courses and training forum or the Tile Blog / Latest Blog Posts
Please note that this thread is old so replying to it may not get a response. You'd be best posting a new thread with a good 4 or 5 word title.
