Kitchen Floor - 20x20 tile 1/4" grout line

[josh1856]

If you click on the images they will link you to a larger image.
This is my first tile installation I wish I would have found this forum sooner...
[DLMURL="http://img149.imageshack.us/my.php?image=img1778ph4.jpg"]

[/DLMURL]
img1778ph4.jpg - Click to see more photos - http://img149.imageshack.us/my.php?image=img1778ph4.jpg

Attached you will find my kitchen layout with my floor design

kitchen1fw1.png - Click to see more photos - http://img145.imageshack.us/my.php?image=kitchen1fw1.png

Specs
All tiles already cut with 1/4" spacers between every tile
20x20 porcelain tiles
45% diagonal patteren
1/4 inch grout
cement backer board
all outside walls are square using 3-4-5 method (along 20' 8" wall and 11' 9")
the north side where the tile meets the floor is a big visual point

Questions
1. Where should I start laying this layout to acheive a nice even line from the border? everything I read says not to start in the corner but it seems to make sense to start in the corner because they are square using 3-4-5.

2. Along the 11' 9" wall i have three full tiles (marked with red X kitchen_2) that wobble north to south (20' 8" wall south) its the only place on the entire floor. Can I just install the tile and fix with mortar?

kitchen2id8.png - Click to see more photos - http://img145.imageshack.us/my.php?image=kitchen2id8.png


Image Page - Click to see more photos - http://img149.imageshack.us/my.php?image=img1781cx7.jpg

3. any additional thoughts/ideas/advice welcomed...'

Thanks,
Josh