Welcome to America Tile Forum, the USA Tile Industry. The Tile Association of America.
You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
wetroom
A shower is a place in which a person bathes under a spray of typically warm or hot water. Indoors, there is a drain in the floor. Most showers have temperature, spray pressure and adjustable showerhead nozzle. The simplest showers have a swivelling nozzle aiming down on the user, while more complex showers have a showerhead connected to a hose that has a mounting bracket. This allows the showerer to hold the showerhead by hand to spray the water at different parts of their body. A shower can be installed in a small shower stall or bathtub with a plastic shower curtain or door. Showering is common in Western culture due to the efficiency of using it compared with a bathtub. Its use in hygiene is, therefore, common practice.
Hi,
I have done a bit of tiling before but I will be tiling our shower room soon and we have a 800 x 800 quadrant shower. The tiles we like are 400mm wide.
We also prefer the look of them lining up and not in a brickwork pattern.
How would be best to tile the shower as I have seen the corners...
Wetroom leaked.
Former and first course of wall tiles removed. WBP ply on joists (shower tray yet to be fit).
Grateful for tiling expertise on upcoming predicament.
Photos explain the following better:
Corner shower - one wall masonry (stepped-render?) and other brick inside studs.
Plan...
hi, im looking to put right a mistake that was made previously in a shower room. i have a 1400 shower tray in a room that is 1480 wide, so at the end of the shower there was a gap that had been filled in with ply and then tiled over, this failed and i have taken the tiles off. my question is how...
Aloha everyone.
I've embarked on a bathroom remodel. I opted to use the hydro block shower pan and system. When I notched my joists and set my presloped pan, I've ended up flush with the existing wood subfloor. As such, now if I put any hardi board on top of subfloor, the transition to the...
Looks like I didn't get the slope correct on this shower bed. Here's water not drained after 10 hours since turning off the shower.
How atrocious is my fix going to have to be? Be honest. I can handle it.
Hello
We recently had our bathroom renovated. We have a walk-in shower, so the tiles are the same in the shower and the bathroom floor. One of the porcelain tiles (large format: 800x800x10mm) has cracked by the walk-in shower. The tile was cut (‘L’ shape cut) to fit the wet room kit. The crack...
Hi. Just thinking about shower trays. Do shower trays with an integrated upstand require sealing where tiles sit upon the tray?
I wondered if this type of tray (if silicone is not required) would be better suited to a bathroom that has a history of silicone going mouldy where the tiles touch...
Hi all,
This forum has been a wealth of knowledge for me while i tackled our new build.
A quick question please regarding wetroom wall tiles and a glass partition.
Where the wall tile meets the glass partition (tile will finish here and not go beyond the glass), do i finish the edge of the...
Deleted member 59001
Thread
edge
former
glass
shower
shower tray
tile
wall
wetroom
Hi all,
This forum has been a wealth of knowledge for me while i tackled our new build.
A quick question please regarding wetroom wall tiles and a glass partition.
Where the wall tile meets the glass partition (tile will finish here and not go beyond the glass), do i finish the edge of the...
Need some advice on a wetroom repair. Tiler installed the tile trim too close to all the edges of the door frame, only discovered this when i went to rehang the door, the hinges cant go flush to the frame and couldnt even put the strike plate back on theres no room at all.
Ive removed the trim...
We paid to have a new shower room installed just over 2 years ago. They fitted a false plasterboard wall in order to make a smaller shower base fit more easily and then tiled straight over the plasterboard. Recently some of the tiles have fallen off the wall (600x300). I removed the front of the...
I have been searching for information on internal corners joints for shower. I have epoxy resin which I have used to join mitred tiles on a difficult angle external corner. Is I OK to use epoxy resin in joint on internal corners? I plan to use epoxy grout for remainder of shower. The shower has...
Hi, I recently had a contractor strip out and replace all the Mastik in my shower as it had failed. It was a very poor job and not colour matched. The new contractor did a good job, or appeared tom with a matched colour (Jasmine) but less than two months on it has completely failed, coming away...
I have just joined the forum and I'm hoping for some advice. I had a leak in my shower which now needs retiling. I have replaced the area of water damaged plasterboard with a sheet of aquapanel. The shower tray is remaining in place and I am now planning to tank/waterproof the three walls that...
What would you guys recommend to finish the internal corners on this niche?
Grout or sealant?
The niche is inside of a shower cubicle
Already grouted the corner of the cubicle then thought maybe it should have been sealant instead.
That can be corrected if need be but wanted to double before...
Hi,
New to the forum. I'm going to be installing a new corner, shower unit with tiled walls, glass doors and acrylic shower pan, as part of a bathroom re-modelling project. I'm not a pro. Would appreciate expert advice on several points.
The new shower will replace an old 'one piece' molded...
This is something that's been causing me a bit of a headache these past few weeks, deciding on which shower former and tanking solution to go for on a timber floor. I was pretty much sold on The Impey Linear 4 former and waterguard kit in the beginning but been looking at other options. I've...
First time renovating a shower, had a few silly questions.
- is adding one layer of 2x2 on top of the flat 2x4 sufficient outer lip (on the three sides without a curb) for my pans mud beds? Shower is 5x3.5 so 2.5’ from drain at longest point. Do I really need 2x6 perimeter if I don’t plan on...
please can I ask if quartz tiles are suitable for inside a shower cubicle. Do they need any special treatment? And do I need to look out for anything in particular?
Thanks
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.