Preparing wall to tile

[Darren1205]

Hi all,

new to the forum and looking for a bit of advice. I’ve stripped out an old bathroom and I’m getting the walls prepared for our tiler to come in.

there is one section that I don’t want to remove if I don’t have too and I’m hoping the tiler would be able to tile over?

So my question is remove and reboard, or will the tiler be able to tile over?

photos attached

many thanks
Darren

 

[Dave]

Welcome, the section at the door you mean. ?

 

[Darren1205]

Welcome, the section at the door you mean. ?

Yes that’s correct, the section right to the door. I don’t mind replacing, but would save a job if adequate to tile. I might add that it would be tiled floor to ceiling, so half way up I’d where the old painted (green) plaster starts.

 

[Dave]

Yes that’s correct, the section right to the door. I don’t mind replacing, but would save a job if adequate to tile. I might add that it would be tiled floor to ceiling, so half way up I’d where the old painted (green) plaster starts.

Clean up and its ok imo.

 

[Darren1205]

Clean up and its ok imo.

Thanks Dave. Would you recommend to do anything to the painted plaster? Just worried it sticks out a few more mm than the tile section we removed below.

 

[Dave]

Thanks Dave. Would you recommend to do anything to the painted plaster? Just worried it sticks out a few more mm than the tile section we removed below.

If it sand or scrape off then thats a better option