Hi. What about wooden bathroom floors

[John S]

If you are going to remove the 18mm chip floor and replace it with WBP ply, what thickness of ply do you need to use if you are going to tile the floor ???

 

[Dan]

Welcome to tilersforums.com | Tile Forums | Tiling Forum!

Hi John S and welcome to tilersforums.com!

 

[Gazzer]

While you have the floor up why not add some more strength in the form of extra noggins and tehn replace floor with 18mm ( or thicker if you can) WBP ply.

 

[John S]

Good idea. Thanks:8:

 

[Gazzer]

If you are joining ply dont forget to leave room for expansion between each piece.

 

[Perry]

you can always overboard chipboard floors with 12mm ply might be a little easer if its solid

 

[Perfectly Tiled]

I was going to say leave the chipboard down and ply with 12mm as above but i take it you are doing this to remove any extra height on the floor to reduce the step.

If thats not correct id over ply it with 12mm WBP screwed 200mm centers.

Scott

 

[DHTiling]

Hello john and welcome..

 

[White Room]

Hi and welcome

 

[The Legend; Phil Hobson RIP]

:welcome:As above, but have you considered backer board, as an alternative. there are plenty around. Good luck. Half a mill Phil.