Encaustic tiles.

[Mark Handyman]

Hi I've recently laid some encaustic floor tiles. They were kept meticulously clean throughout laying. They were sealed with the recommended sealant, fila fob, before grouting.
However, The cleaner they recommend isn't cleaning them up enough to put a finished seal on. After 3 attempts.( fila ps87).The grout colour is limestone on a patterned white tile.
Any ideas how to give them a good clean? Thanks.

 

[Spud]

any pictures?

 

[Mark Handyman]

See attached pic

 

[Spud]

you could try getting some saw dust from the pet shop mix 50ml of diesel through half a builders bucket of saw dust and rub this into the tiles make sure you ventilate the room and wear gloves it will clean the tiles up nicely

 

[peteablard]

You need to replace the tile that's upside down too, bottom left of the picture...... Sorry, had to mention it!

 

[The D]

you have one up side down

 

[White Room]

You need to replace the tile that's upside down too, bottom left of the picture...... Sorry, had to mention it!

Hawkeye....:lol:

 

[peteablard]

you have one up side down

nice to someone else who's still on the ball at this time of night Deano

 

[Mark Handyman]

OOps, will do cheers

 

[Cement Tile]

Depending on what type of sealant you plan to use, you might consider if the thin residue of diesel that might remain on your tile is compatible. It would not be w/ the sealant we have been recommending lately which is more of a top-coat than an impregnator. You can sand lightly w/ 200 or 250 grit sandpaper. Any courser will leave visible scratches, any finer will polish and can leave polished hot spots which may show later. Just a thought.