Drilling new tiles
UK Tiling Forum; Established 2006
Welcome to the UK Tiling Forum by TilersForums.com, built in 2006 by Tilers, run by Tilers.
View all of the UK tiling forum threads, questions and discussions here.
Tilers Forums Official Sponsors
R
Rich
As above unless she is driving you mad, in that case about 2 weeks 
J
jay
😳
D
Deleted member 1779
I think that the main concern when drilling tiles is the water mess that might get onto fresh grout. So as advised above probably not good to drill when
tiles just grouted. But as soon as the grout goes off then away you go.
Our diamond cores work more like a grinder than a drill so you dont actually disturb the tile too much.
Done this way you can pretty much drill it while the addy is soft if you have to. But we dont recommend you make a thing of it.
In this article the basin is being fitted to the wall and the tiles had gone on that day.
I would suggest (for other readers) that if you are going to drill holes in tiles then
try to do it BEFORE you have grouted. This will remove the doubt that water coolant
will wash away soft grout if done too close together.
All the donkey work has been done on this job ahead of the grouting.
I think because it was an article photoshoot [ie not a real bathroom!!] then the
basin was fully fitted well before the grouting was done. Not even sure the
guys at Professional Builder even bothered to grout up this demo.
But the point remains that you can pretty much drill as soon as you want
BUT give the addy some time to cure and do it if you can before grouting.
Tiles already grouted? Then wait until it wont absorb and murky water used
to cool the diamond core drills
This video shows how mucky tiles can get when drilling. Again tiles are ungrouted so not spoilt
[video=youtube;F2Hk1eO8rOM]http://www.youtube.com/watch?v=F2Hk1eO8rOM&feature=player_embedded[/video]
tiles just grouted. But as soon as the grout goes off then away you go.
Our diamond cores work more like a grinder than a drill so you dont actually disturb the tile too much.
Done this way you can pretty much drill it while the addy is soft if you have to. But we dont recommend you make a thing of it.
In this article the basin is being fitted to the wall and the tiles had gone on that day.
I would suggest (for other readers) that if you are going to drill holes in tiles then
try to do it BEFORE you have grouted. This will remove the doubt that water coolant
will wash away soft grout if done too close together.
All the donkey work has been done on this job ahead of the grouting.
I think because it was an article photoshoot [ie not a real bathroom!!] then the
basin was fully fitted well before the grouting was done. Not even sure the
guys at Professional Builder even bothered to grout up this demo.
But the point remains that you can pretty much drill as soon as you want
BUT give the addy some time to cure and do it if you can before grouting.
Tiles already grouted? Then wait until it wont absorb and murky water used
to cool the diamond core drills
This video shows how mucky tiles can get when drilling. Again tiles are ungrouted so not spoilt
[video=youtube;F2Hk1eO8rOM]http://www.youtube.com/watch?v=F2Hk1eO8rOM&feature=player_embedded[/video]
Last edited by a moderator:
R
Rich
What grout and adhesive was used? It should say on the bag of grout.
D
DHTiling
Most grouts state 2 weeks for power showers etc.
Don't mind me while I bump up some of the old threads. I wont be doing this much more. Just the last few in the Tile Drilling forum - How to Drill Porcelain Tiles. Just one of the many tiling advice forums.
