It’s New tools tuesdays - TilersForums.com

[Cranbrook]

I tried just holding a small stiff brush against my mixing paddle today and it worked fine..

 

[GoneGuy]

Karl dahm roller for decoupling membranes,
Ready for a job coming up soon

 

[On one]

@Tom Astley can you knock one these up tomorrow?

 

[hmtiling]

Karl dahm roller for decoupling membranes,
Ready for a job coming up soon

View attachment 100322 View attachment 100323

They've changed the design. I've worn through the blue roller bit on mine. Emailed them to see if I can just replace that bit and no reply. Bit disappointed with the lack of response. Roller is about 3 years old though

 

[Old Mod]

I've worn through the blue roller bit on mine. Roller is about 3 years old though

But Harry, your apprentice is not meant to wheel you around on it tho.
You should try walking home from the pub!

 

[Flintstone]

Slightly different tray to mine, mines a metal grid, the blue tray looks to sit lower to the ground. Brilliant tool for any amount of matting, don’t twist it as it can twist the mat

 

[Old Mod]

, don’t twist it as it can twist the mat

How would you know Andy?
You only use Hardie!

 

[Flintstone]

Here’s the proof!

 

[Old Mod]

Here’s the proof! View attachment 100339

Here’s the proof

. I would overboard with 6mm cement board such as hardie backer then tile. Make sure the underfloor heating has been commissioned before you do anything.

 

[Flintstone]

That statement was referring to oveboarding an underfloor heating system in between joists and over boarded with chipboard. I’ve recently quoted on a job with the same system, so I did my home work on it and that was what Tilemaster advised was the best way to deal with it. I can tag them in if you want a bare knuckle brawl ?

 

[Old Mod]

That statement was referring to oveboarding an underfloor heating system in between joists and over boarded with chipboard. I’ve recently quoted on a job with the same system, so I did my home work on it and that was what Tilemaster advised was the best way to deal with it. I can tag them in if you want a bare knuckle brawl ?

Andy, chill!
The contents of the post have nothing to do with anything.
It’s the most recent post I could remember where you mention Hardie.
That is ALL!
I don’t care about why, where or who told you.
I apologise for assuming you would read my remark in the way it was intended.

Oh I so wish I hadn’t bothered, and I’m sure you do too.

 

[Flintstone]

A simple sorry Andy, I was wrong would have sufficed!

 

[Old Mod]

A simple sorry Andy, I was wrong would have sufficed!

Wrong? About what.
You do suggest boards over matts where possible.

Ok if it makes you happy.
I’m sorry Andrew I was wrong......










.......:about the fact that I thought you had a sense of humour!

 

[hmtiling]

They've changed the design. I've worn through the blue roller bit on mine. Emailed them to see if I can just replace that bit and no reply. Bit disappointed with the lack of response. Roller is about 3 years old though

They emailed today and have already despatched the spare roller. Thumbs up Karl Dahm

 

[Italy]

clean now from monday