Tiled bath panel access-half bond tiles

[Amanda]

Hi

I have tiled the whole of my bathroom and just have the bath panel to complete.....it is a short bath, we have built a wooden frame for it and wish to tile in the same as the walls. The tiles are smooth metro 50x200 that are in a half bond pattern.

I intend to use backerboard, screwed onto ply and the wooden frame as my base.

I think I should do it to allow access but want a neat finish. I can't do a concealed square due to the half bond.

Any suggestions?

Thanks in advance!

Please note I am just a DIYer

 

[Perry]

At the tap end cut the board half bond and use Silicon on the joint and edges. Just cut it short so the tiles on the panel just sit on the fixed board.

 

[Andy Allen]

Or fix the whole panel with mirror screws....... If excess is required remove the whole panel as you would a standard bath panel

 

[Perry]

I would also just make it out of plasterboard cheaper and easier. Unless you mean widi type of backerboard. Hardibacker type is cement board, but forget the ply.

 

[jobdone]

Use 30mm wedi/Jacko board. Tile as normal then Silicon joint for access and cut through if you ever need to.