laser liner laser level

[Spud]

I bought a laser liner laser level 3 years ago and can honestly say i have used it less than dozen times switched it on before xmas and it is out of level does anyone know if they can be repaired? it hasnt been knocked or dropped

 

[nybor62]

you should be able to get it calibrated gary

 

[phil w]

Hi Gary you will be able to get it calibrated bought a hilti second hand and got it calibrated cost £60 that was about 3yrs ago could get expensive it it needs repairing

 

[Spud]

where would I need to take it to get it calibrated ?

 

[DHTiling]

Hi Gary, contact the laser manufacturer to seek recommended calibration comps..

How much is it out..?... most makes are + - .05mm over lnr mtr..

 

[Spud]

Hi Gary, contact the laser manufacturer to seek recommended calibration comps..

How much is it out..?... most makes are + - .05mm over lnr mtr..

not sure how far out it is but it is clearly obvious to the eye when comparing it to my dewalt laser i guess about 2-3mm over 1,5-2m so pretty poor it does have a tilt feature which may be interfering with the self leveling ??? I will have a look on line to see if i can get it repaired

 

[White Room]

I bought my laser off these and they recalibrate http://www.laser-level.co.uk/calibration.html

 

[The Plasterer]

Here is instructions on how to Calibrate your own Laser Level from ehow website.


[h=2]Instructions[/h]

[h=3]Things you need[/h]

• Laser level
• Laser tripod
• Marking pole

• Place the level on top of the tripod and position the tripod at a distance of 32 feet from the marking pole.
  
  
  
  
• Make a measurement from the tripod to the top mark on the marking pole and mark the measured point.
  
  
  
  
  
• Turn the tripod so that the laser is pointed at another marking point at 180 degrees from the first marked measurement.
  
  
  
  
• Move the tripod so that the laser is only 3 feet from the second marked measurement. Adjust the tripod so that the laser level is in line with the marked point.
  
  
  
  
• Turn the tripod back around to face the first marked measurement. If the laser doesn't line up perfectly with the first mark then the degree of the level needs to be adjusted until the laser lines up with the first mark. Adjust the degree that the level is displayed at by turning the knob on the side of the laser until the laser lines up with the first measured mark
  

Hope this helps .

 

[kaharrison9]

Hi Gary

I sent my old Laserline auto cross 3 to Laserlevel shop on line in London to see if they could repair it when it was damaged.

It was condemned and i bought another from them.

There are not many places that stock Laserliner but i'm sure this company can either calibrate or repair.

Shame tradetiler stopped stocking the autocross as i think it's a cracking laser.

Kev

 

[AliGage]

Is it not cheaper to buy a new one? I think the Ryobi cross pendulam laser i got only set me back 40-50 quid.

 

[kaharrison9]

The laserliner autocross 3 costs i think around £220.

Superb laser and have no interest in changing so a recalibration if not to expensive probably once in a while i could justify.

3 years i've had mine so is probably due.

 

[Perry]

speak to Adam laser line 07855350175