Battipav New Profi 130-160 Tile Cutter

[Italy]

this morning checked the measurement bar, was)))) not straight.
however however, below there are 4 for adjusting screws.
settled.
now ok

 

[Italy]

Libet Event Poland - February 2016

 

[Italy]

I wanted to end test speech. and comparison with sigma
then: the cutter, do very good cuts. sigma -
as I said above, the handle flows faster. sigma -
weight: 19 kg strong point. sigma -
Price: € 460 including vat / sigma much more.
weak points: the metrics of supporting bar. it's weak. now I try edit.
adding the other fixing screw. (Additional hole already present)
I'm waiting to be called technical BATTIPAV. to find a solution ++++ .sigma.
concluding, in my opinion.
the cutter is very good if have to make few cuts. (for me is ok).
if, instead, you need to make many all precise cuts. all the time. (unlikely to happen).
better to buy a sigma ++++.
this is just my impression. do not take at face value

 

[Rosco100]

Have been using one of these for the last few weeks and it works great ! Especially the weights of each cutter The 600 is only 9.9 kg,Haven't had any problems snapping anything, Ultimate test was on a tile by Lea Ceramiche called tecnoquartz 60x30 X 12mm and had no problems taking a 20mm X 600 cut,We have all the sizes from 400 upto 1600.....

 

[Bill]

Have been using one of these for the last few weeks and it works great ! Especially the weights of each cutter The 600 is only 9.9 kg,Haven't had any problems snapping anything, Ultimate test was on a tile by Lea Ceramiche called tecnoquartz 60x30 X 12mm and had no problems taking a 20mm X 600 cut,We have all the sizes from 400 upto 1600.....

post some photos of it in action please.

 

[Italy]

I sell new BATTIPAV x pro 60.
sigma, forever

 

[Italy]

 

[Italy]

Have been using one of these for the last few weeks and it works great ! Especially the weights of each cutter The 600 is only 9.9 kg,Haven't had any problems snapping anything, Ultimate test was on a tile by Lea Ceramiche called tecnoquartz 60x30 X 12mm and had no problems taking a 20mm X 600 cut,We have all the sizes from 400 upto 1600.....

I'm sorry but I disagree.
I tested this morning xpro 600, 60x60 x1,
without offending anyone, it is a cutter, from third world.
those who use sigma, throws BATTIPAV in the ocean immediately.

 

[Italy]

now I go to sell, the 1600 .........

 

[Italy]

sold profi 160