3 way mitre

[Cabnero]

Hi guys. Hope you can help me. Beeb banging my head against a wall today. Can you cut a 3 way mitres using square edge trim. Been really struggling. If so any advice would be appreciated. If not what would my options be. I know you can mitre the tile but have never done this before. Any help would be much appreciated.
Thanks

 

[White Room]

Why would you need to mitre a square edged trim ?

 

[John Benton]

Like this you mean, get a trim that has a corner piece to finish

 

[WetSaw]

^^^^^ is the winning answer.

 

[AndY mac]

The only other way to do this without a corner piece is to do 45s on the six points of the trims bringing them to point. Time consuming and gives you a sharp corner

 

[Flintstone]

If using box trims it's all good if you aren't using the flat square edge ones, all you can do it mitre the top two

 

[Diggy]

Currently using metal trim on site work and i do it like so : using the pic above , if you said the left tile was the window reveal ( I'm talking half height tiling here) , the trim to the top right I cut square to the edge of the tile , then mitre the other 2 pieces . Looks fine for a a site work finish , . In fact a lot of the other guys I know moaned when I started doing it cos they just cut it square and overlap it - gross . Personally I couldnt leave it like that.

Diggy :0)

 

[Cabnero]

Thank guys fir all your answers. I ended up mitring the top 2 and cut the other one straight. It looks OK. I sometimes over think things and end up in my own backside!!!