Did I mess up on tiling over floorboards ?

[Bigsasquatch]

Hi,

Laid my first tiles over floorboards last weekend using DITRA, but I am worried I may have made a few mistakes.....

a) Firstly made sure that boards were level , clean and solidly screwed down, lightly washed with pva and allowed to dry completely.

b) Was given some adhesive along with the DITRA, which could be used wet, or as a contact type adhesive - applied to both boards and DITRA backing and then allowed to go tacky before pressing down firmly. Should I have laid the DITRA into wet adhesive for a better bond ?

c) My main issue is that I am worried I used the wrong kind of adhesive. I went for Evo-Stick Tile-a-Floor flexible adhesive/grout for laying on wooden floors ( ready mixed version ). I am assuming that the ready mixed version cures in Air ( i.e. not a chemical cure ), and whats worrying me is that having laid on top of DITRA , once the grout lines cure, there is going to be no permeation of air or loss of moisture from the adhesive under the tile, so it wont cure.............should I have used a different adhesive ?

In addition, I may have laid the adhesive slightly too thick, but without leaving it to cure. Difficult to know what will happen.....do I pull it up and start again ?


Cheers

BIG S

 

[IvegotsTILE]

I think you answered your own question with (c),
I would never use ready mixed stuff on floors or I would never use adhesive and grout in one.Should never use pva either.
You should have used a flexible floor adhesive and flexible grout,I think your right about it not curing properly I'm afraid.Personally I'd pull nthe lot up and start again.

Good luck

 

[grumpygrouter]

I think you answered your own question with (c),
I would never use ready mixed stuff on floors or I would never use adhesive and grout in one.Should never use pva either.
You should have used a flexible floor adhesive and flexible grout,I think your right about it not curing properly I'm afraid.Personally I'd pull nthe lot up and start again.

Good luck

Me too.:sad_smile: Ardex do materials specifically for Ditra, have a check on their site www.ardex.com.

Grumpy

 

[wivers]

Ive & Grumps got it spot on Bucket gear on floor is pretty poop. Theres a link for laying ditra matting on here http://www.tilersforums.com/tiling-...fixing-schluter-ditra.html?highlight=Schluter .

Have a look at that mate might help a bit.

 

[DHTiling]

you put ditra down with flexi adhesive on timber and then tile on top of ditra with normal rapid set not flexi adhesive.......dave.....

read this......http://www.tilersforums.com/floor-tiling-forums/2715-uncoupling-membrane-explained.html

 

[IvegotsTILE]

Sorry just realised I didn't say to put the tiles on with ordinary rapid set,I meant for you to use flexi to put the ditra down.Luckily Dave's always on the ball:wink_smile: