I've got a Vitrex 900 Pro bridge saw and it's worked brilliantly for me so far but i'm having a problem with the pump. There is water coming through but it only seems to be about half the amount. This started after be turning it back on in the middle of some cutting.
I've cleaned the reservior tank right out and run clean water through but it's still not flowing enough, any ideas? The saw does get a lot of use, I cut for about 3 - 4 hours at a time and the pump is removed from the tank after each session and the filter romved and cleaned.
I've cleaned the reservior tank right out and run clean water through but it's still not flowing enough, any ideas? The saw does get a lot of use, I cut for about 3 - 4 hours at a time and the pump is removed from the tank after each session and the filter romved and cleaned.
rrr: I'm tempted to buy another and have it just in case as I really can't afford to be without one at the mo.