Primer required?

[Scholester]

Hi,
I have done a few tiling jobs for myself over the past few years and would rate myself as reasonably competent!:lol:
I like to ask questions before going in head-first so as to limit any avoidable mistakes.
So, first question for you hepful chaps is..... I am laying UFH in my flat (kitchen & bathroom) which is constructed with block and beam floor with 100mm polystyrene insulation and 22mm chipboard floor. I am using 6mm insulation panels which I believe need to be stuck to the chipboard floor with Rapid Set Flexible Adhesive.
Now, do I have to first prime the chipboard floor with acrylic primer before sticking the boards down and do I have to prime the top of the insulation board before applying the Adhesive for the tiles?
Finally, The UFH mat is 3mm thick, can I lay the mat within the wet Adhesive and lay the tiles directly on this or do I have to lay the mat on a thin bed of adhesive first and let this go off before the tile adhesive bed and tile!?
Hope I am making myself legible!?

 

[brian c]

clean the floor and check with the adhesive manufacturer if the substrate needs primed prior to laying boards.Once boards are layed and the ufh matt is positioned,you could use a slc then tile it?

 

[The Legend; Phil Hobson RIP]

clean the floor and check with the adhesive manufacturer if the substrate needs primed prior to laying boards.Once boards are layed and the ufh matt is positioned,you could use a slc then tile it?

On the money Brian

 

[Scholester]

Thanks guys, it's better to ask before getting stuck in than getting stuck in then getting stuck!:smilewinkgrin:

 

[doug boardley]

it sounds like a floating floor, hope you're not thinking of tiling it:yikes:

 

[Scholester]

Not sure if it's floating - all stud walls are wood framed and screwed to the floor?
And yes, I AM tiling it (on top of the fixed down warmup boards):ciappa:
I will let you know in a year or so wether you can say I told you so!!!:mad2:

 

[doug boardley]

if it's a floating floor, you won't have to wait a year!

 

[TrumpersUnited]

The Chipboard will have to be very secure. I would use thicker contruction board than 6mm as well at the very least 10mm. Make sure contruction board is screwed as well as stuck down using a SPF. Also i would use a suitable levelling compound for the UTH and then use a 2 part adhesive and flexible grout.

As the other fellow says if its a floating floor be very careful

 

[DHTiling]

You need to have ZERO deflection to tile floating floors....and use S2 type adhesive..

Not something i would do lightly.

 

[Scholester]

Doug,
Can you please define a floating floor?
Is this were the floor is not screwed to the base that it sits on?
The flat is 35 years old and the floors have no sags or creaks. Is it ok to use SLC on this then adhere the insulation boards to the SLC with 1 part Weber Flexible Rapid Adhesive? Would it make a difference to use a two part milk with the Flex?