Need help with cuts

[Chrisc123]

Hi guys, I have started a job of 45m² with 600 x 600 porcelain. I'm having trouble when I'm cutting the tile. I'm left with a tail at the end of the cut and at this rate I won't have any tiles left. I'm not sure what I'm doing wrong. Is my wheel height set wrong ? Is it just bad technique? Need help bad ! I'm using a sigma 3c3m BT

 

[Dan1234]

I would fit a new cutting wheel

 

[Chrisc123]

I would fit a new cutting wheel

It hasn't seen much use to be fair, im DIY so it's only had one other job. I think I might have solved it. I was scoring a lead at the front and back of the tile which I think was giving me the problem. Does that make sense?

 

[Leroy Brown]

🙂

It hasn't seen much use to be fair, im DIY so it's only had one other job. I think I might have solved it. I was scoring a lead at the front and back of the tile which I think was giving me the problem. Does that make sense?

Did you fix this problem as I am having this issue with the same cutter. Leaves a tail on the end every cut.