Mitre jointing - help

[doug boardley]

these were mitred too, the nib ends were rubbed down with fine sandpaper as I had no choice but to cut through the glaze,

 

[Aston]

As above for me, sometimes trim will not work eg. 22.5 deg. If you mitre manufactures edge 1mm away as stated above. You can achieve a good finish

i never get tired of looking at those pics!
the work you did on that house was stunning phil!! the kitchen floor, the bathrooms, everything was absolutely 1st class!!

 

[The Legend; Phil Hobson RIP]

Thanks Ed, it is always nice to do a job for people with good taste