Recent content by Corin

  1. C

    Ardex Problem with Ardex Grout FS Innocent Black

    I know this is late but the problem you faced is from water. More water equals a whiter finish. Best case the adhesive dries at 1mm per week. 2mm joint is going to be sometime in Julember. If your tile is 600mm then at least 30 weeks. The issue is that you get the grout wet whilst its going off...
  2. C

    Slate tile tolerance.

    Use a Flex CS60 or a 4" after they are down to cut the grout lines wider rather than cutting each one individually. And yes I fully expect them to not be rectified or the same thickness. just laid some limestone that was 16-26mm thick and not square.
  3. C

    Is this Addy ok for 20mm marble slabs

    If you're buttering them then I'd use a 10mm for both to get a 10mm bed under them. Depends how level the floor is though, I guess. It could be too thin in places with tiles that big. I'd definitely use clips with them being that size on latex.
  4. C

    Is this Addy ok for 20mm marble slabs

    You need a white adhesive and it needs to be made with latex not water. You need to fully butter them and then seal them with a capillary sealant/breathable when the adhesive has fully dried like Lithofin Stain Stop MN. Primer too. You need to seal them prior to grouting or just not get grout on...
See more

Featured Threads

Advertisement

Tilers Forums UK | UK Tiling Forum
https://uktilingforum.co.uk | UK Tiling Forum
Back