Norton TT200 clipper

[doug boardley]

Have just bought a Norton clipper tt 200 em.
Had a quick blast on it seems very good,appears to have a good spec,2 discs and a 800w motor.
Was tempted to go for the Rubi nd 200 but the differance in cost should pay for a decent laser level

was the difference about £600 then Kev?:smilewinkgrin:

 

[kaharrison9]

Good guess Doug
At 3 of the main tile shops i bobbed in the figure of around £600+ was been banded around for the Rubi 200ND 200.Strangely the ND300 was slightly cheaper than the 200 at one place.
Out of curiosity i asked how much the TX1200n was and that came at £840 after discount.
Already new they wouldn't be cheaper than tradetiler but shows how competive TT's prices are
Kev

 

[poynton phil]

The guard does come off to an extent. I've managed to do plunge cuts with mine. The top does rust a bit but over all its a top cutter. Have lost my little rubber bung though that sits in the drain hole. Pesky little thing. Got some electrical tape over the hole currently :yikes:

I lost my plug too, if your've got a caravan shop near you go in there, i got 2 for £2, and they fit perfect.