gyvlon screed

[nybor62]

I know quite a few tilers who have used it and general comment is that it is nice gear to use. I know at least 2 guys who have returned existing addy on site in favour of this. Don't knock it till you've tried it says I

if i dont like it you may end up wearing a bag of it:lol::lol:

 

[jay]

I know quite a few tilers who have used it and general comment is that it is nice gear to use. I know at least 2 guys who have returned existing addy on site in favour of this. Don't knock it till you've tried it says I

not knocking it just reading specs as brief as they are 😳

 

[Ajax123]

if i dont like it you may end up wearing a bag of it:lol::lol:

I'll wear me old suit then......

 

[Diamond Pool Finishers]

i have just spent half the night looking at spray rendering machine's , they also pump these screed's that was hard work today, still all done on the floor :yikes: 6 ton's

 

[Ajax123]

i have just spent half the night looking at spray rendering machine's , they also pump these screed's that was hard work today, still all done on the floor :yikes: 6 ton's

The spray render machines I have see will deffo pump Gyvlon but very slowly. Typically the pumps I see are Putzmeister SP11 type which can pump 5m3 in about 20 minutes. General spary render machine (we used to use one for demos) will take about 90minutes to pump the same volume of screed. Not recomended for the serious screeder but usefull for the plasterer who sometimes does screeding as well. That is unless you have a much bigger pump than the ones I have seen.

 

[diamondtiling]

i have just spent half the night looking at spray rendering machine's , they also pump these screed's that was hard work today, still all done on the floor :yikes: 6 ton's

Thats proper work Dave, 6 tonnes! well done mate.

 

[nybor62]

we have been using the gbta addy for over a week now , it goes of like lightening , we found best to mix pourable one spreading one fixing, only lasts about 20 mins, but the building were working in is very warm though , plenty of clean water and clean buckets out after every mix.

after 5 mins you can stand on the tiles ,as we found out when some one walked straight across them, and did,nt budge any of them , dont think i would want to work with it to often,