Dewalt d24000 running slightly out

[Ollie02948]

My cutter has just started to run not true. It's approx 2mm out over 600mm. I've been cutting 15mm limestone for the last 2weeks so something might want tightening up. What's best way to adjust his to get it good again? Cheers ollie

 

[DHTiling]

Lift the head unit up , so it catches the tile by 2mm.. then slice across a tile full length and then measure the width of the cut along the length if that is out then you can adjust the rail alignment with the adjustment screw.. if it is ok then it is either tile movement whilst cutting or cutting too fast causing blade wander.

 

[Ollie02948]

I will do that Tmro thanks again.