hi all
im a diy tiler and have done a few small tile jobs but this will be a first for me
im fitting a new bath and shower over the bath and have the following questions
after i strip off the old tiles i undertand i need to waterproof the walls around th bath [tanking]
the walls are plastered...
hi all
im a diy tiler and have done a few small tile jobs but this will be a first for me
im fitting a new bath and shower over the bath and have the following questions
after i strip off the old tiles i undertand i need to waterproof the walls around th bath [tanking]
the walls are plastered...
Hi
I am currently getting my bathroom refitted and am installing a semi roll top bath into an area that previously was completely covered by a bath. So it was only tiled up to the bath edge. My installer has asked what he should do with regards to the tiling, obviously it needs to go floor to...
Hello, 1st time tiling job coming up. Old bathroom suite is ripped out and now ready to tile. Watched loads of how to videos and ready to give it a go. I have a question with regards to the bath. The bathtub is just your standard tub with front cover. The question is can I lay floor tiles to...
I’m looking for bathroom tiles previously stocked by the Bath Store. We believe they were called Newham and made by British Tiles.
Does anyone have spares or know where the old stock went?
Hi, I have used Kerdi membrane several times around showers but never around a bath and would like some advice please. Ill attach a pic, but my question is should the Kerdi membrane run behind the bath. I.e. the membrane fitted and then the bath installed up to it. Or is it ok to install the...
I’m tiling around a bath. The backing board is ply and is slightly wobbly. Should I secure it before I start tiling? The trouble is if I secure it then it’s not level as the bottom of the backing board sticks out slightly. If I leave it slightly wobbly then I will get a straighter...
Hello! First time tiling a bath. My issue is that the shower wall is about .5" (1.5cm) narrower at the top than at the tub edge over a span of about 7 feet (208cm). Should I begin tiling with the 2x6 inch bullnose edge and then trim the tiles on the inside corner edge? I'm just having a tough...
Hi folks!
Forum newbie here, be gentle (or not, I can take it).
I've boxed in around a corner bath, attached Aquapanel on to boxing with Silicon and screws so that it is flush with the bath top, and a slight incline towards the bath.. All good so far (or not, feel free to interject / mock...
I have about a 40mm gap between the bath edge and the wall, I plan to tile the wall, do you recommend boxing this in or using some kind of sealant? Really struggling to find a large enough ceramic or plastic lip edge to fit.
What is the best way to tile round a bath?
Basic stuff pros take for granted but is not obvious for me! The subfloor is t&g floorboards and I will use 6mm backer boards. The walls are cement render.
Q1) I was thinking it is better to tile down to the top edges of the bath so the tiles ovelap...
When tiling a bath side do you do it as a permanent fixing or do you allow access - screwing it with mirror screws for example do if can come off for checking leaks or repairing trap etc
Hello Tilers
I recently fitted a bathroom for a (paying) friend.
One of the problems I encountered was the soil pipe which runs behind, then turns to run along the tap end of the bath. I made up the gap with 76 x 51 mm (3''x 2'') CLS, I tiled it forming a slope to shed water, grouted and then...
Hi all,
Recently finished a bathroom renovation only to find that underneath the cardboard I laid in the bottom of the brand new bath there was a small chip. It was a multi trade job so who knows how it got there
Has anyone had any experience with this spot repair kits?
Which is easiest to...
Due to customer changing from bath panel to wanting tiles around bath need some advice on how to make it look best. I'll attach some photos and any advice on what looks best would be great thanks
Dropped a tile in a bath yesterday, I'm sure we've all been there.
Decided to try one of these repair kits from tool station before spending a small fortune on a bath repair man.
The results were much better than expected, well worth getting one to keep in the van..
Hi, we have a half roll top bath (so is a straight edge and connected to the wall on two sides, but doesn't have a panel).
Picture below:
Our tiler and our plumber are saying two different things and I don't know what is best.
Our plumber is saying he isn't happy with the walls being tiled...
i changed to new bath and have gap all way around. the tiles were mamaris grey tiles from wickes over 10 years ago, no longer sold anywhere .Any ideas what i can do to edge around bath 4 inch gap ( tiles or self adhesive tile ? pvc ?)
thanks
lee
Hi all!
Since everyone was so helpful with near tiling disaster last time I am hoping to get a bit more advice now that we are coming to tile our bathroom floor.
We want to make sure we do it right first time!
The floor of the bathroom is wood floorboards. They're in relatively good nick and...