layout question!

[garretridge]

have a job booked in 147m2 porcelain two sizes 600sq and 300sq tiles done in a hopscotch pattern running through 6 rooms no door bars needs to flow through. two halls-sunroom-kitchen-utility and a huge family room whats the best why to tackle the layout on this one any ideas appreciated!

 

[murf]

I would normally set out from the biggest room. with the hopscotch you will get pretty random cutting so you dont have that many options .
Also I would put a movement joint at all the doorways as there is usually a lot of cracking in these areas. I would also make sure the floor area is nice and flat, as the tiles are so big. Good luck with the job.

 

[hillhead]

every 300mm you have a joint so plenty to play with,use a good laser and know where every minimum wall cut is.snap plenty of lines and stick to them

 

[Deleted member 1779]

Is it a concrete floor and screed or raised wooden floorboards on batons?

I also assume its all at ground level and on a solid foundation and not a mixture of concrete and timber ?

If its upstairs and on joists there will be movement.

 

[garretridge]

Is it a concrete floor and screed or raised wooden floorboards on batons?

I also assume its all at ground level and on a solid foundation and not a mixture of concrete and timber ?

If its upstairs and on joists there will be movement.

Ground floor only with underfloor heating throughout!