room

Hi, I am new to the forum but wondering if someone could please answer a few questions I have relating to a new wet room I am going to get installed. The location of the new wet room is an old Victorian house at first floor height (on a suspended wooden floor). I am hoping to specify...

Love it or hate it this is how it ended up chaps, finished for crimbo now merry Christmas to you all have a well earned rest . Cheers kop

Finished pics of a shower room I recently tiled

Hello, I am fitting an offset quadrant shower cubicle (which has a large rounded corner) and would like to have a fully tiled floor (as in a wet room) rather than the usual surface stone tray. The problem is that all of the wet room preformed trays are oblong and I can see there will be a...

hello, So I’ve been reading a few posts on here about laying mosaics, can’t seem to find anything for wetroom formers that already have the fall built in. Can anyone give me a few tips to laying mosaics over a wetroom firmer please? Area is around 2.5m2 and custard hasn’t chosen mosaics yet so...

I have a wet room that needs a really deep clean, unfortunately the tiled surface is very much like sandpaper and shreds any mop that comes near it. My method to clean would be using LTP Grimex and a deck brush, rinse remove dirty water with a wet vac repeat as needed then a coat of LTP Matt...

Hi there, we fitted a large Fiora shower tray into our upstairs bathroom a few years ago when we got the house refurbished. (pics attached) Problem is the weight of the tray has caused it sink into the wooden floor beneath, creating a 1mm gap between grout and tray and leaking a lot of water...

Hi all, Need a wetroom tiling urgently. All fully prepped wedi board on floor and walls. 20sqm in total.

Hi, First time here and hoping this is an easy question! I am installing a wet room upstairs and going back to joists but I also want to install low profile wet underfloor heating (I already have it), what will give me the best surface to tile on and support a bath on top? So I was planning...

Hi, I’m planning on tiling a very small cloak room, currently original wooden floorboards. Plan is too use 12mm ply but I keep reading this a bad idea?!? This is not a wet room so is ply ok?

I am a reasonably competent DIY tiler having fitted out kitchens, showers, toilets etc for my three daughters (and myself when they give me time!) but in all my projects gravity has been my friend. For a change I am gutting a shower / toilet in my own 200 year old house where the walls are up to...

Hello, i am looking for somebody who can not only tile the room but can do the whole installation including: fitting the waste outflow (concrete floor) boarding the 2x stud walls tanking the shower area tiling the whole room (floor and walls) fit shower enclosure Would like survey and to discuss

Hey folks, Just looking for some advice on a wet room I have. Floor wise I have wooden joists overlaid with moisture resistant flooring (can’t remember exact thickness) with a kudos shower tray, overlaid with RIW membrane and screws over the non shower area before it was all tiled over. I have...

Hi all. Our wet room grout is coming out due to movement. Floor shifts 2-3mm when pressure applied. We got a quote for £*** to repair. Do you think this is a reasonable amount? We're in the North West (near Chester). The £*** covers: Remove old tiles (90cm x 120cm area) Fix the movement...

Hi guys Would appreciate any opinions or advice on the below 3 pictures please: Tiles 100x200 flat metro with 2mm spacers Red Lines are 90 Degree internal corners, white bit is the window As you walk into the room the middle wall is directly infront with the window to the left and the full...

As the title suggests, Schluter have just unveiled their new advanced wet room course at their training centre in Coalville Leicestershire. Myself, @andy tiler, @Localtiler, and a few others who were unable to attend, were invited to trial their new course over the last couple of days. The...

Hi, I am looking to specialise in wet rooms and wondered if anyone can advise on good training for this in the east midlands and also if typically you can charge a bit more for this type of work? cheers, Ben.

Hi all In a kind of 'Payment' for all the advice i have got from here i have decided to do a build thread for my wet room, it may help someone in the future it may not but here it goes! Room size is 1.8M x 2.2M, at the end of the extension i finished building a last year. I work full time so...

Hi guys Long time reader and lurker, got so much great advice... Quick question, i have a Anhydrite screed currently that was put down in a wet room (Wet UFH 50mm thick) it is currently 50mm lower than the finished floor height needs to be. My question is, would it be the following buildup be...

I am building an extension which has a ground floor shower room. So I looked at differerent types of panels and reckon that the Bushboard Nuance are what I want. The shower is 1200x800 with a window in the 1200 end and going to panel the toilet and basin wall, so five in total. These panels are...