Questions and tiling advice in the DIY Tiling Forum - Main DIY Tiling Forum : How to Tile, carrying out your First Tiling Job? - Post in this DIY tiling advice forum we have here on TilersForums.com. The largest tile advice website on the internet..
Search the forum,
Sticky Threads
- Sticky
As stated we love seeing your DIY stuff! Take a couple of photos and show off your project here!!! I'll go first with my dad's handiwork tiling the bathroom!
- Lou
- 1
- 691
- Sticky
Hey guys! After tiling my bathroom and ensuite last year which would not have been possible without the fantastic advice and knowledge on this website I'm now planning to tile our back porch...
- Sticky
I have underfloor heating and a concrete floor. I cleaned the floor then PVAd it. I followed instructions on the bag of adhesive (cement based, highly polymer, modified, thin bed tile adhesive)...
- Asc
- 42
- 18K
- Sticky
Hello
I am a DIYer and after a successful shower tile project set about tiling bathroom floor. Victorian terraced house, previous floor - exposed original floorboards. After research and...
- Deleted member 46792
- 59
- 22K
- Sticky
Hello
I'm making some beginner's mistakes and also need advice please....
I've tiled the shower but the tiles fitted perfectly at the bottom of the corner - and didn't at the top so I have a 1cm...
- KateJ
- 43
- 11K
- Sticky
Three tiles fell off my wall in my kitchen, and underneath I scraped off the combed white tile adhesive and also another white layer with a knife. It exposed some gypsum and paper like material...
- Sticky
Hi,
I've been doing alot of research prior to tiling the ground floor of my home, approx 40m2. The structural floor is 18mm Ply and after reading all the horror stories of failed floors I am...
- AD1
- 51
- 10K
- Sticky
Hi All,
I'm about to start my first tiling job (at home) and after thinking about steps have a few questions regarding corners (inner corner(s).
I have 5 msq area to cover, and my tiles are...
- diy_dude
- 50
- 20K
Normal Threads
Looking for some advice on paving my driveway.
I'm in Australia, so no freezing issues.
I have jack hammered off the existing brick paving and mortar back to the slab. Slab is 100mm thick and in...
- blute
- 1
- 2K
Hi
I have just stripped off some horrible mosaics off our fireplace to find they were only stuck on with glue gun and silicone.
I am re tiling with brick slips which I have pre sealed already...
- Rob Collins
- 5
- 5K
hi all ,
just in the middle of fitting a raised floor in a garage area , membrane 5 x 2 tmbers ,and a 22mm moisture boards then hardiebacker to be tiles with 600 x 300 tiles
ive a drain...
- biffo17
- 2
- 2K
This is my bathroom wall after taking a few tiles to see what lurks beneath. The top surface of the plaster has come off quite easily so I presume this will be the case when I take the rest off. I...
- Jon W
- 5
- 3K
Hello,
Ok i've recently redone the kitchen and after a wee bit of advice/sanity check.
I have a section of plastered wall 1400x2300 which has been sealed and i plan on putting up split face...
- Sand-man
- 11
- 5K
I have used Starwax products on my terracotta tiles floor and in parts of the room it has now developed (over a couple of days) a whits deposit. This can be scraped off with my finger nail but...
- Sally Burgin
- 6
- 3K
Hi Guys, I have a balcony and the floor is tiled but, the floor is too low or should I say the balcony wall is too high! So I want to raise up the floor level and was thinking of using decking...
- MargolisMarmite
- 5
- 4K
