Recent content by bsc ceramics

All done now, was just the linkage could'nt get it into gear so not as bad as first thought. still a p##s off though

Morning tiler's Clutch just went on my van Good start to the day

Used Rubi all my working life but after a run in with their rep over spares for my cutter i wont even buy a rubi sponge now

Agree with bob think its a bit wide for a grout joint....😀

Iv used the rubi and the sigma and the rubi was the better system, easier and smoother to use, dont know anything about the razor though.

I agree I just have a 40 and a 70 all iv ever needed both about 15/20 years old but great cutters

Can you still get a ts 30 ?

go for the TX-n a real good cutter. I'm a Rubi man always have been and iv had mine quite a few years

John I'm shocked... I thought you were a rubi man like me:anguished:

have to agree with @timeless john on this one only ever used Rubi and never felt the need to change. TS 40 TX 70 that's good enough for me, RUBI RUBI RUBI.. :p

again your right but their ars a few chancers out there taking work away from proper tilers that have done the job all there lives...

your right there, cant be a bad thing, gets rid of the cowboys

ewpa, its the best way to go for an experianced tiler. i did it last year and am always being asked for my card (nvq) on sites. on a lot of sites now its no card no work and it will only get worse so its best to be prepaired

we've all had days like that, some customers are priceless, just smile and take the money...

the tx has a floating bed which is so much better for cutting porcline tiles, i think thats the only differance