Where to start first row?

[Gaz_R_87]

So probably a basic question but this is my first attempt at tiling and want to get it absolutely right.

If I start with a full tile from the upstands, there are several sockets which would be in the way of the 2nd row.

Would it be better to reduce the height of the 1st row to less than a full tile so that the cuts around the socket don't look too small or would I be able to get away with cutting the 2nd row to fit around the socket without the uncut bit being too narrow or weak?

Thank you!

 

[Tile Marble Granite]

Follow the pattern, full tile at the bottom. The socket cover would need to sit on top of tile. Good luck!

 

[Gaz_R_87]

Follow the pattern, full tile at the bottom. The socket cover would need to sit on top of tile. Good luck!

Hey TMG thanks for the reply. Do you mean have a full tile above the upstand, and then just cut tiles so the socket is on top of a thin part of the 2nd row (once cut)? Thank you!

 

[Tile Marble Granite]

Hey TMG thanks for the reply. Do you mean have a full tile above the upstand, and then just cut tiles so the socket is on top of a thin part of the 2nd row (once cut)? Thank you!

start from the bottom with full tile