New Rubi magnet cutter - Tile Advice

[GoneGuy]

has anyone on here got a Rubi magnet cutter? I'm looking to get Rubi tr600 magnet but a Rubi Rep has recommended I get the tr710 magnet as the tr600 you can only just get a 600tile in it?
Just looking for some advice before I buy a new cutter.

 

[Dumbo]

has anyone on here got a Rubi magnet cutter? I'm looking to get Rubi tr600 magnet but a Rubi Rep has recommended I get the tr710 magnet as the tr600 you can only just get a 600tile in it?
Just looking for some advice before I buy a new cutter.

I don't know if it any better than the tr600 I had but I gave it away and got to tx 700 which incidentally I just sold and a sigma 3c3m

 

[Italy]

: Oops:: Oops:
This question,
It could be a drama

 

[LM]

I'm biting my tongue

 

[GoneGuy]

Sorry to start the old Rubi sigma debate, I was hoping there might be one more person than me that uses Rubi haha

 

[Italy]

Sorry to start the old Rubi sigma debate, I was hoping there might be one more person than me that uses Rubi haha

There is no one anymore.
you have to resign yourself to buy one yourself.
Then test and tell us the result.

 

[GoneGuy]

As soon as I get one I will post up my review.
It's got to better than my genesis cutter haha

 

[Kyle Knowles]

I've bin looking at a montolit cutter recently there so red and enticing and the few videos I've seen they can cut some real small pieces

 

[Kyle Knowles]

I'm not sure if they do a box to store them in tho which is pretty big for me only having limited space in the van

 

[Italy]

I'm not sure if they do a box to store them in tho which is pretty big for me only having limited space in the van

They do not do the box

 

[Kyle Knowles]

They do not do the box

Thanks for the info

 

[Italy]

Thanks for the info

I would have another thing to say ...
Every cut you make at 45 °,
you have to fix the red bracket,
Because the rear metric bar is not as sigma.
Has a different metric scale,
It's been like that forever, and I do not understand why they do not change the system.
sin, because they are good cutter.

 

[Dumbo]

Sorry to start the old Rubi sigma debate, I was hoping there might be one more person than me that uses Rubi haha

I've used both . Ts40 ts 60 ts40 plus tr600 tx700 tx900 and now I got sigma because having used both IMHO I think sigma is better for me .

 

[Dumbo]

I would have another thing to say ...
Every cut you make at 45 °,
you have to fix the red bracket,
Because the rear metric bar is not as sigma.
Has a different metric scale,
It's been like that forever, and I do not understand why they do not change the system.
sin, because they are good cutter.

I also got a monti and I did like the fact that red measure stop could flick up out the way for different length cuts. .....Until it broke. Also nowhere near south smooth as the sigma's.

 

[Dumbo]

@Adey1980 just had a look at this cutter in Google images look very similar to the tr600 I had . If you are dead set on a rubi get yourself a tx 700 it's an altogether better piece of kit especially for modern porcelain tiles also I find I do a few 660 x330 which the tr would be no good for